Access Point mode is the most suitable operational mode to set up Wavlink range extenders in homes, offices, or places where the only wired network is available. It is because the Wavlink access point setup allows the extender to connect to the host AP using a wired connection and provide wireless internet access.
In other words, doing a Wavlink access point setup allows the Wavlink WiFi extender to act as a hotspot in the home network. It means higher connectivity and speed range throughout the home. Now, let us take you for a walk through the steps to install a Wavlink range extender in the AP mode.
Steps to Do Wavlink Access Point Setup
The following guidelines will provide you with deep insight into doing the Wavlink access point setup:
Step 1- Unbox the Extender
If you are doing Wavlink access point setup for a brand new extender, then let’s begin with unboxing your extender. While unboxing you will also find detachable antennas, a networking cable, and a user guide with your Wavlink range extender.
You need to be very careful while unboxing the extender as its delicate parts can get damaged if mishandled Medicare Supplement plans in Texas. Once you are done with unboxing, move to step 2.
Step 2- Power Up and Connect Your Devices
Now, the next step involves powering up and connecting your WiFi devices. For the former, you need to plug your WiFi devices into power outlets and press their respective Power buttons. However, do not forget to check about the workability of power sockets. Any damage to them won’t be good for your WiFi devices. Now, set the position of the Mode Selector button to AP.
After powering up your WiFi devices, you need to grab an Ethernet cable and insert its ends into the ports of your WiFi devices. However, make sure that the cable is free of cuts and the connection is finger-tight. You are also free to make use of the wireless source to connect your devices.
Step 3- Access Wifi.wavlink.com
The next step is to access the wifi.wavlink.com web URL. It is the default web address of your Wavlink extender. So, switch on your computer and load any web browser you wish to use. However, your wish should be fulfilling two conditions that are the web browser must be updated and free of cache.
Now, move the cursor to the URL field of the internet browser and type wifi.wavlink.com into it. Thereafter, press the Enter key. You will now be taken to the login page asking for the default admin password of the Wavlink range extender.
Step 4- Log in to the Extender
Now, get hold of the Wavlink WiFi extender manual and look for the default password of your Wavlink device. Once found, type it into the password field on the Wavlink extender login page. Know that the default password of the extender is case-sensitive.
After typing in the password, you need to select the language in which you want to do Wavlink access point setup. So, select the language you find convenient and click the Login button.
Step 5- Follow On-Screen Prompts
The moment to hit Login the setup wizard of your Wavlink range extender will welcome you. Now, you will be prompted to make some customizations. However, the on-screen prompts will appear to guide you about the same.
So, read the instructions with your eyes open and let the Wavlink access point setup process get completed.
After installation, the Wavlink extender will become an active hotspot for all the devices present within its range. So, no chance of slow internet.
This was all about how to do Wavlink access point setup. Here’s to the hope that the guidelines mentioned above will help you do Wavlink WiFi extender setup in the access point mode and you will gain access to a high-speed internet connection. If this post was helpful, leave a word of appreciation in the comment section.